Table of Contents
Advertisement
Table 4-5
Item
GPIB
For the next message, disconnect the GPIB cable from the GPIB connector. Then, press
the
Enter
Open GPIB, then press [Enter].
Press [Exit] to abort
TRIGGER
For the next message, connect the BNC cable between the Ext Trig In and Out connectors.
(BNC)
Then, press the
Connect In to Out, then press [Enter].
Press [Exit] to abort
KEY
For the next message, press any front panel key.
DIAG:KEY
OK: [Enter] twice or NG: [Exit] twice
Then, the message will be changed as shown below:
DIAG:KEY
OK: [Enter] twice or NG: [Exit] twice
where label must be the name of the key you pressed.
Press another key to continue the key diagnostics. Press the
were good, or press the
HV-LED
For the next message, press the
key if the LED does not blink.
Exit
DIAG:HV-LED
YES: [Enter] or NO: [Exit]
DGTL-I/O
For the next message, disconnect any cable from the digital I/O port. Then, press the
key to start the diagnostics, or press the
Open DGTL-I/O, then press [Enter].
Press [Exit] to abort
BEEPER
For the next message, press the
or press the
DIAG:BEEP
YES: [Enter] or NO: [Exit]
Front Panel Reference
Setup Menus
To Perform Diagnostics
key to start diagnostics or the
key to start diagnostics or the
Enter
Press any key.
[label]
key twice if any response was bad.
Exit
Is the LED blinking?
key for no beep sounds.
Exit
Is beeper making 2 sounds?
4-30
Description
key to return to the previous menu.
Exit
Exit
key if the High Voltage LED is blinking, or press the
Enter
key to return to the previous menu.
Exit
key to hear two types of beep sounds every second,
Enter
Keysight E5260/E5270 User's Guide, Edition 6
key to return to the previous menu.
key twice if all responses
Enter
Enter
Advertisement
Table of Contents
