To Use Series Resistor; To Use Filter - Keysight Technologies E5260 Series User Manual

NOTE
NOTE

To Use Series Resistor

This instruction connects the series resistor to the specified channel internally.
1. Press the key and the
Shift
2. Press the arrow keys, and select ON to connect the series resistor.
3. Press the key if you are setting the resistor for another channel, and
OutCh
perform 2.
4. Press the key to make the setup effective, or press the
Enter
changing the setup.
A series resistor is mounted on each module. If you use a series resistor, the voltage
you set is applied to the near side of the series resistor. Thus, the voltage will be
divided by the series resistor and the device under test.
The series resistor cannot be used for the measurements that use the high resolution
SMU (HRSMU) connected to the Atto Sense and Switch Unit (ASU) or the
measurements that use 1 A range of the high power SMU (HPSMU).

To Use Filter

This procedure connects the filter to the specified channel internally.
1. Press the key and the
Shift
2. Press the arrow keys, and select ON to connect the filter.
3. Press the key if you are setting the filter for another channel, and perform
OutCh
2.
4. Press the key to make the setup effective, or press the
Enter
changing the setup.
A filter is mounted on each module. It assures clean source output with no spikes or
overshooting.
Keysight E5260/E5270 User's Guide, Edition 6
key.
On/Off
key.
V/I
Front Panel Operations
Applying Source Output
key to cancel
Exit
key to cancel
Exit
5-19