Table of Contents
Advertisement
Step 3. Setting up SMU2, forcing DC voltage, and measuring DC current
1. Press the
OutCh
information is displayed in the Setting Parameter area.
2. Press the
MeasCh
displays ------ (no data to display status).
3. Press the
CPL Value
part of the CPL value. The CPL shows the compliance value.
4. Press the Right arrow key to move the cursor on the arithmetic point.
5. Press the Up arrow key to set the CPL value to 100 mA, and press the
to fix the value. Then press the
6. Press the
On/Off
In the following example, the measured data is just an example. During the repeat
measurement, you may not be able to read the measured data.
Stat
Meas Value # 1
0.00010nA
Lock Meas Trigger Error Integ
R em ote
Step 4. Stopping measurement
Press the
Single
is still effective.
The LCD changes the display as shown below. The following data is just an
example.
Stat
Meas Value # 1
0.00015nA
Lock Meas Trigger Error Integ
R em ote
Keysight E5260/E5270 User's Guide, Edition 6
key until the S-ch status area displays 2. The SMU2 setup
key until the M-ch status area displays 2. The Meas Value area
key. The cursor appears on the lowest digit of the integral
Enter
key. The SMU2 starts voltage output and current measurement.
Meas Value # 2
A
2
R epeat
Output
M- ch
key. The SMU2 stops the measurement. However, the source output
Meas Value # 2
A
2
R epeat
Output
M- ch
key again. The cursor disappears.
Setting Parameter
OUT:
2
CPL: 100.0mA
S- ch
Setting Parameter
OUT:
2
CPL: 100.0mA
S- ch
Getting Started
key
Enter
Shift
0.00 V
Shift
0.00 V
1-5
Advertisement
Table of Contents
