Table of Contents
Advertisement
Step 1. Turning on the Keysight E5260/E5270
Step 2. Setting up SMU1, forcing DC voltage, and measuring DC current
NOTE
Getting Started
Connect the power cable from the Keysight E5260/E5270 to an AC power outlet,
and press the
switch.
Line
After the self-calibration, the LCD shows the following display:
Stat
Meas Value #1
OFF
Lock Meas Trigger Error Integ
R em ote
1. Press the
CPL Value
of the CPL value. The CPL shows the compliance value.
2. Press the Right arrow key to move the cursor on the arithmetic point.
3. Press the Up arrow key to set the CPL value to 100 mA, and press the
to fix the value. Then press the
4. Press the
key. The SMU1 starts voltage output.
On/Off
5. Press the
key. The SMU1 starts current measurement.
Repeat
In the following example, the measured data is just an example. During the repeat
measurement, you may not be able to read the measured data.
Stat
Meas Value #1
0.00020nA
Lock Meas Trigger Error Integ
R em ote
The Output indicator shows that DC voltage or current is applied by the channel
specified by the S-ch indicator.
The Repeat indicator shows that the repeat measurement mode is set.
The Meas indicator shows that the measurement channel is performing the
measurement. You will see the indicator if the measurement time is long enough to
display the indicator. Even if the channel performs repeat measurement, you will not
see the indicator if the time to measure one data item is too short to display the
indicator.
1-4
Meas Value #2
A
1
1
Output
R epeat
M- ch
S- ch
key. A cursor appears on the lowest digit of the integral part
key again. The cursor disappears.
Enter
Meas Value #2
A
1
1
Output
R epeat
M- ch
S- ch
Keysight E5260/E5270 User's Guide, Edition 6
Setting Parameter
OUT:
0.00 V
CPL: 100.0uA
Enter
Setting Parameter
OUT:
0.00 V
CPL: 100.0mA
Shift
key
Shift
Advertisement
Table of Contents
