Chapter 7 Parameter Settings; Procedure For Setting Parameters - Mitsubishi Electric MELSEC iQ-F Series User Manual

7
PARAMETER SETTINGS
This section explains the parameter settings necessary for EtherNet/IP and general-purpose Ethernet communications with
FX5-ENET/IP.
For details on each operation of GX Works3, refer to GX Works3 Operating Manual.
7.1

Procedure for Setting Parameters

1.
Add the "Information Module (FX5-ENET/IP)" in the GX Works3.
[Navigation window]  [Parameter]  [Module Information]  Right-click  [Add New Module]
2.
Select the "FX5-ENET/IP".
[Navigation window]  [Parameter]  [Module Information]  [FX5-ENET/IP]
3.
Set the parameter.
4.
Write the parameter settings to the CPU module.
[Online]  [Write to PLC]
5.
The settings are reflected by resetting the CPU module or powering off and on the system.
The following steps are required when EtherNet/IP is used.
6.
Connect the personal computer and FX5-ENET/IP, and start EtherNet/IP Configuration Tool for FX5-ENET/IP.
7.
Set the communication parameter of EtherNet/IP. (Page 55 EtherNet/IP Configuration Tool for FX5-ENET/IP)
8.
Write the parameter settings to the FX5-ENET/IP. (Page 54 Writing Parameters)
*1 FX5-ENET/IP can be added to GX Works3 also from the module configuration diagram.
*1
7 PARAMETER SETTINGS
7.1 Procedure for Setting Parameters
7
49