Selecting The Plate Loader Sample Injection Mode [With Plate Loader] - Beckman Coulter CytoFLEX Instructions For Use Manual

Daily Startup
Logging into the Software
3
Select
Initialize
4
Load the sample tube.
NOTE
The sample tube holder accommodates 1.5-mL, 2.0-mL, and 12 x 75 mm sample tubes.
5
Manually swing the sample tube holder gently back to the standby position (see
6
Manually raise the sample tube holder gently to the sample acquisition position (see
Figure 1.12) and hold the tube in that position.
7
Select
Boost
8
Select
Run
The sample runs at the designated flow rate and the Cytometer begins to acquire data.
9
When you are satisfied with the data, select
10
Wait for the data acquisition to finish or select
holder and move it to the sample loading position (see
11
Select
Backflush

Selecting the Plate Loader Sample Injection Mode [With Plate Loader]

Select
Sample injection Mode
Injection mode, the Manual Injection mode, and the Plate Loader Injection mode. The Plate Loader
Injection mode can be used for running small volumes using the following plates: 96-well
flat-bottom, 96-well V-bottom, and 96-well U-bottom.
4-12
.
to transfer the sample to the flow cell.
.
to clean the probe.
in the Cytometer Menu to change between the Semi-Automatic
to record the data.
Record
. Then, manually lower the sample tube
Stop
Figure 1.12).
Figure 1.12).
B49006AS