Table of Contents
Advertisement
5.6.2
Meas func
Specifys the measurement functions for the areas.
You must configure different settings depending on the measurement function.
Average
z
z
The average of the measured values within the area
are output.
Tips
• Parts where an alarm occurs will not be used in the calculation of the average value.
• For locations where the measured value is larger or smaller than the area, the measured values will
not be used in the calculation of the average value.
P height
z
z
The largest measured value within the area is output.
Tips
• Parts where an alarm occurs will be ignored.
• Within the range of the area, if there are measured values that are larger than the area, the peak
height value will be the upper limit of the area.
• The peak is determined by comparing the sizes of the measured values, so when "Axis dir" is set to
"Far+," the peak will be in relation to the lower part of the screen.
B height
z
z
The smallest measured value within the area is output.
Tips
• Parts where an alarm occurs will be ignored.
• Within the range of the area, if there are measured values that are smaller than the area, the bottom
height value will be the lower limit of the area.
• The bottom is determined by comparing the sizes of the measured values, so when "Axis dir" is set to
"Far+," the bottom will be in relation to the upper part of the screen.
Ramco National
800-280-6933 | nsales@ramcoi.com
Area
Profile
www.Optex-Ramco.com
Area Settings
5-25
Advertisement
Table of Contents
