Table of Contents
Advertisement
1.4 Installation
1.4.1
Installation Precautions
When you install this product, ensure that there is
sufficient space around the product in order to prevent
overheating.
The LS series performs measurements by emitting a
parallel laser beam and receiving the reflected light.
During measurement, ensure that the laser beam and
reflected light is not blocked by the target object.
Before using the product, check that stray light, which
is reflected by a wall or by highly reflective objects,
does not have an effect on the measurements.
1.4.2
Installing the Sensor
1 Insert the included mounting screws (two M4 × 50 mm screws) into the mounting holes to temporarily affix
the sensor to a location that is roughly in the desired location.
2 Measure the distance between the sensor and the detection target object.
3 Adjust the sensor position on the basis of the measurement result, and then use the included nuts and
washers to fix the screws in place.
Ramco National
Laser exposure
direction
800-280-6933 | nsales@ramcoi.com
Space required
above the sensor
40 mm or more
Space between sensors
40 mm or more
Laser exposure
direction
Stray light
迷光
www.Optex-Ramco.com
Installation
1-7
Advertisement
Table of Contents
