Calculation Formulas - Fastus LS Series User Manual

5.7.4

Calculation Formulas

You can perform calculations with the measured results of multiple areas.
Set up to two calculation formulas. The calculation formulas are defined as shown below. Select from the
following values for the calculation targets and for the operator.
[Setting target:] Calculations 1 and 2
Calc target1 and Calc target2
z z
Select the targets to use in the calculation. Select from areas 1 to 4.
Operator
z z
Select the operator to place between the areas.
Actual calculation example
z z
To perform measurements such as level difference measurements and angle measurements, use the
calculation settings.
To perform a level difference measurement, measure the heights of the upper and lower surfaces of the
level difference, and then subtract one height from the other.
 Area settings
To perform an angle measurement, measure the angles of the two components that make up the angle
that you want to measure, and then subtract one angle from the other. When a measurement is
performed with the following formula, the outer angle of the gap or protrusion is output. To output the
inner angle, set "180" for the offset value.
 Area settings
Ramco National
Calc target 1
Area 1
Area 2
Area 3
Area 4
Area 1 Area 2
Area 1
Area 2
800-280-6933 | nsales@ramcoi.com
Operator Calc target 2
Area 1
+
Area 2
–
Area 3
Area 4
 Calculation formula
—
Area 1
(Average height) (Average height)
 Calculation formula
—
Area 1
(Angle)
Calculation Settings
Area 2
Area 2
(Angle)
www.Optex-Ramco.com
5-31