Specifications - Fastus LS Series User Manual

Specifications

7.1 Specifications
Model
Measurement range
Width of view (at measuring distance)
Light source
Laser class IEC/JIS
FDA
Spot size
*1
Linearity Z axis
Repeatability Z axis
*2
Resolution X axis
*3
Sampling period
Display
Indicators
External input
Control output
Analog output
Communication I/F
Temperature drift (typical example)
Power supply voltage
Current consumption
*4
Protection category
Operating temperature/humidity
Storage temperature/humidity
Operating illuminance
Vibration resistance
Shock resistance
Material
Weight
*1 Defined with center strength 1/e
affected when leak light other than that of the specified spot size is present and when there is a highly
reflective object close to the detection area.
*2 Average height measurement of a white workpiece with a center width of 5 mm, smoothing performed 8
times, moving average performed 32 times (with the default settings)
*3 With a measurement distance of 75 mm
*4 Power supply voltage: 24 VDC not including the control output load current and including the analog
output
7-2
Ramco National
LS-100CN
17 mm (at 75 mm), 27 mm (at 125 mm)
Red laser, wavelength: 655 nm, max. output: 1 mW
Typical value: 5 ms (when measuring the whole view in "Hi-res" mode),
Power indicator (green), laser emission indicator (green)
Selectable from bank, trigger, hold, reset, laser emission stop, and offset
3 NPN open collector outputs,
max. 100 mA/30 VDC
(max. residual voltage: 1.8 V)
4 to 20 mA, out of measurement range: 24 mA
RS-485 half duplex (9.6 kbps to 4.0 Mbps)
12 to 24 VDC (+10%, -5%, including ripple)
high-frequency lamp: 3000 lx or less
10 to 55 Hz; double amplitude 1.5 mm;
2 hours in each of the X, Y, and Z directions
3 times in each of the X, Y, and Z directions
laser emitter and receiver covers: glass
(13.5%) at the center of measurement range. The sensor may be
2
800-280-6933 | nsales@ramcoi.com
100 ± 25 mm
Class2
CLASS II
0.3 × 32 mm
±50 μm (±0.1% of F.S.)
2 μm
25 μm
max. speed: 0.5 ms
Dot matrix display
3 PNP open collector outputs,
max. 100 mA/30 VDC
(max. residual voltage: 1.8 V)
(max. load impedance: 300 Ω)
0.05% of F.S./°C
Max. 180 mA
IP67
-10 to +40°C/35 to 85%RH
(no condensation or freezing)
-20 to +60°C/35 to 85%RH
(no condensation or freezing)
Sunlight: 10000 lx or less,
Approximately 50 G (500 m/s
Housing: die-cast zinc and PC,
Approximately 300 g
LS-100CP
),
2
www.Optex-Ramco.com