Table of Contents
Advertisement
Input/Trigger Settings
Inner hold
z
z
Hold is turned on or off from the sensor or from LS-Navigator. This is only valid when IN2 is set to
"BANK2."
Inner trig
z
z
The trigger is turned on or off from the sensor or from LS-Navigator. This is only valid when IN3 is set to
"BANK3."
5.2.3
Input polar, Inp filter
Input polar
z
z
● N.O.:
When input is received through an input terminal, the input terminal turns on.
● N.C.:
When input is received through an input terminal, the input terminal turns off.
Inp filter
z
z
Set the external input filter time to prevent chattering. Set this value in steps of 5 μs.
5.2.4
Trig action
The LS series performs a measurement each time that the trigger conditions are met. Set the action of this
trigger.
Cont
z
z
Imaging and measurements are performed continuously while the trigger is on.
1shot
z
z
One measurement is performed when the trigger turns on.
Count
z
z
When the trigger has turned on the number of times specified by "Trig count," one measurement is
performed.
By using an encoder as the trigger, you can perform measurements once per fixed distance.
Trig count
z
z
Specifys the number of triggers to use when "Count" is selected for "Trig action."
Trig delay
z
z
Sets the delay time between the trigger meeting the camera conditions and the camera actually taking
images.
Set this value in steps of 5 μs.
5.2.5
Offset target
Select the target on which to execute the offset when IN4 is set to "Offset."
● Indivi:
You can use the input time to select the target on which to execute the offset.
● All:
The offset is executed on all the outputs.
● OUT1 to OUT3: The offset is executed on the specified output.
5-6
Ramco National
800-280-6933 | nsales@ramcoi.com
www.Optex-Ramco.com
Advertisement
Table of Contents
