Output Settings; Out Target; Thresholds And Output - Fastus LS Series User Manual

Output Settings

5.8 Output Settings
5.8.1

Out target

Select the output target area.
[Setting target:] Outputs 1 to 3 and analog output
Select the target from the following parameters.
● Area1
}
● Area2
The measured result of the area is set as the output target.
● Area3
● Area4
● Calc1 }
The calculation result is set as the output target.
● Calc2
The illustrations shown in the explanations are when "Out polar" is set to "N.O." and "On Timing" is set to
"Out range".
5.8.2

Thresholds and Output

[Setting target:] Outputs 1 to 3
Upper limit/Lower limit
z z
Set the upper and lower limits (thresholds) that will be used
to perform output judgments.
Tips
Thresholds are judged based on the offset value.
For example, output will turn on as shown below when the
offset value is 100 mm and the upper limit is 10 mm.
Offset value (100 mm) + Upper limit (10 mm) = 110 mm
(Refer to the figure to the right. Changing the offset value
will shift the upper and lower limit accordingly.)
5-32
Ramco National 800-280-6933 | nsales@ramcoi.com
Measurement not possible
Upper limit
Lower limit
ON
Output
OFF
Offset value
Upper limit
0
Lower limit
www.Optex-Ramco.com