Offset/Offset Value - Fastus LS Series User Manual

Output Settings
5.8.4

Offset/Offset Value

When offset input is received, values are added to or subtracted from the current display value so that it
becomes the value set with "Offset value."
The offset value can be set for each output.
When the offset operation is executed, values are added to or subtracted from the measured value of (1) the
area that the output is referencing or (2) a calculation. (The parts indicated with dotted lines in the following
figure.)
[Setting target:] Outputs 1 to 3
Tips
• "Offset" and "Offset value" operate on areas and calculations.
Therefore, the values of any other calculations or outputs that are referencing the area or calculation in
question will also be changed.
In the above figure, if the offset operation is executed on output 1 (the dotted line on the left side of the
figure), the values of calculation 1 and output 3—which are referencing area 1—will also be changed.
• Thresholds are judged based on the offset value.
For example, output will turn on as shown below when the offset
value is 100 mm and the upper limit is 10 mm.
Offset value (100 mm) + Upper limit (10 mm) = 110 mm
(Refer to the figure to the right. Changing the offset value will
shift the upper and lower limit accordingly.)
5-36
Ramco National
Area Area Area Area
1 2 3 4
Calc Calc
1
Out Out Out
1 2 3
800-280-6933 | nsales@ramcoi.com
Area
Calculation
2
Output
Offset value
Upper limit
Lower limit
0
www.Optex-Ramco.com