Axis Dir; On Timing - Fastus LS Series User Manual

5.9.3

Axis dir

Set the direction in which to increase and decrease the height direction measured value.
Select "Near+" (the measured value will increase toward the side near to the sensor head) or "Far+" (the
measured value will increase toward the side far from the sensor head). In both situations, the origin is the
center of the measurement range (at 100 mm).
(-8500,25000)
+
(-13500,-25000)
Coordinates with "Near+"
Tips
• In the horizontal direction, the measured value always increases to the right. This cannot be changed with
the above setting.
5.9.4

On Timing

Specify the judgment output operation.
● Out range
Output turns on when the measurement result is outside the range specified by the threshold.
● In range
Output turns on when the measurement result is within the range specified by the threshold.
5.9.5 言語/Lang
Change the display language. This setting has no effect on operations.
You can set the display language separately for the sensor and for LS-Navigator.
5.9.6 Screen Saver
Specify the operation after 30 seconds without any access to console buttons.
"LCD OFF" is recommended while "LS-Navigator" is used or heavy communication is needed through RS-
485 I/F.
● Dark
The back light will get dark without any access to console buttons.
Ramco National
+
(-8500,-25000)
(8500,25000)
(0,0)
+
(13500,-25000) (-13500,25000)
Coordinates with "Far+"
Figure: Axis direction and coordinates
800-280-6933 | nsales@ramcoi.com
Common Settings
+
(8500,-25000)
(0,0)
(13500,25000)
www.Optex-Ramco.com
5-39