Area Settings
5.6 Area Settings
The LS series sets "areas" within the measurement range, and then performs measurements on these
areas.
You can specify up to four areas.
5.6.1
Measurement Areas
Sets the positions and sizes of the areas within the camera area.
Areas are rectangles. You can also specify areas so that they overlap.
Camera area
Area
Figure: Example of area settings
If the profile does not pass through the area, the measured result will become "------ (measurement not
possible)". Set the area so that measurement is possible.
Area
Profile
Figure: Profile and area that result in measurement not being possible
5-24
Ramco National
800-280-6933 | nsales@ramcoi.com
www.Optex-Ramco.com