Timing Charts
7.4 Timing Charts
This section explains the timing charts of LS series measurements and output.
7.4.1
Measurement
The timing charts of LS series measurements are shown below.
Tolerance judgment (upper and lower thresholds and hysteresis)
z
z
When "Out polar" is "N.O." and "On Timing" is "Out range"
Upper limit
Measured value
Lower limit
ON
Judgment output
(control output)
OFF
When the hold mode is "None"
z
z
When the hold mode is "None," hold input is ignored and the measured result is always updated to the
latest value.
Measured
value
ON
Hold
OFF
ON
Reset
OFF
7-6
Ramco National
Measurement not possible
800-280-6933 | nsales@ramcoi.com
Hysteresis
t
www.Optex-Ramco.com