Setup Procedure; Connecting To The Sensor Head - Fastus LS Series User Manual

4.4 Setup Procedure

4.4.1

Connecting to the Sensor Head

When the sensor head and computer are connected, click "Connect" to connect to the sensor head and
automatically update the measured value.
If the connection fails, the message "Failed to connect to LS sensor unit." will be displayed. When you close
the message, the common setup screen will be displayed.
Select the port that is connected to the sensor head and the communication speed, and then click "Connect"
again.
After you have established a connection between the sensor head and the computer, configure the
measurement settings with the sensor head.
Click "Settings" to switch to the "Input/Trigger" screen. Click the tabs on the left side of the screen in the
order shown to set each item.
Reference
For details on the measurement settings, see the following sections.
• 4.4.2 Input/Trigger Settings
• 4.4.3 Camera Settings
• 4.4.4 Profile Settings
• 4.4.5 Area Settings
• 4.4.6 Calculation Settings
• 4.4.7 Output Settings
Ramco National 800-280-6933 | nsales@ramcoi.com
Setup Procedure
4-15
www.Optex-Ramco.com