10 Horizontal Arm Brake Cable Installation; 11 Horizontal Arm Brake Removal; 12 Horizontal Arm Brake Installation - GE AMX-4+ Technical Manual

GE MEDICAL SYSTEMS
REV 5
3 10 Horizontal Arm
Brake Cable Installation
3 11 Horizontal Arm
Brake Removal
3 12 Horizontal Arm
Brake Installation
1. Slide ball end of brake cable into slot in cable bracket on end of chain on brake
and cable assembly. See Illustration 3-7.
2. Route anchor end of cable around pulley on end of mounting plate to opposite
end of support bar and insert in slot.
3. Replace anchor nut on cable end and take up slack by turning nut clockwise. Do
not overtighten.
4. Replace cable clip, with brake cable in place, on bar support assembly and secure
with one machine screw.
5. Check that the cable and chain move freely.
6. Loctite the anchor nut.
7. Install horizontal arm brake and cable assembly. Refer to Section 3-8.
1. Remove horizontal arm brake and cable assembly. Refer to Section 3-7.
2. Disconnect brake electrical cable connectors to remove from connector bracket.
3. Loosen remaining capscrew holding brake to mounting plate. See Illustration
3-7.
4. Slide brake off brake sprocket shaft.
1. Slide brake onto brake sprocket shaft.
2. Secure brake with single capscrew in end of mounting plate. See Illustration 3-7.
3. Position brake electrical cable connectors in connector bracket and reconnect.
4. 'Install horizontal arm brake and cable assembly. Refer to Section 3-8.
3-13
(MODEL 2169360, 2236420 & 2275938 SERIES)
DIRECTION 2173225-100
AMX-4+ SERVICE