10 3 5 Horizontal Arm Brake Cable - GE AMX-4+ Technical Manual

GE MEDICAL SYSTEMS
REV 5
ILLUSTRATION 10-15
ANODE AND STATOR CABLES

10 3 5 Horizontal Arm Brake Cable

ILLUSTRATION 10-16
HORIZONTAL ARM
BRAKE ROUTING
STRAP POINT G
3. Continue routing and ty rapping the collimator cable along the anode cable to
strap point G." See Illustration 10-15.
ANODE
CABLE
STATOR
4. The horizontal arm brake cable is also picked up and retained until strap point
G." See Illustration 10-14.
5. There is a large loop after strap point G" before the cable enters the bottom of
the vertical column assembly terminal box and is connected to the terminal strip
AMX# A1 TS1. See Illustration 10-12 and Table 10-1.
1. The horizontal arm brake cable exits the left side of the horizontal arm outer tube
and is ty-rapped to the bottom of the anode cable just below clamp point H."
See Illustration 10-16.
10-12
(MODEL 2169360, 2236420 & 2275938 SERIES)
CLAMP POINT H
STRAP POINT M
AMX-4+ SERVICE
DIRECTION 2173225-100