Dispensing Steam; Dispensing Hot Water; Dispensing; Programming The Hot Water - Wega WBAR EVD Use And Maintenance Manual

Dispensing steam

6.7
Carefully move the steam nozzle using the specific
anti-scald rubber grip (9).
Do not direct the steam towards hands or other parts
of the body. Do not touch the steam nozzles with bare hands; use
the appropriate PPE.
Before using the steam nozzle, the condensation
draining operation must always be carried out for at
least 2 seconds, pushing the tap lever (8) back.
"PURGE" function
• IImmerse the steam nozzle (10) into the liquid to be heat-
ed;
• lower the tap lever (8) by pulling it forwards;
• the quantity of steam dispensed will be proportional to
how far the lever has been moved;
• to finish dispensing, return the lever (8) to the vertical po-
sition.
To optimally froth the milk, follow these simple rules:
• Heat only the amount of milk you intend to use; once heat-
ed, it will have to be completely poured from the jug and
not heated again;
• Froth the milk which should be at a temperature of around
4°C.
To keep the steam nozzle tips in perfect working order,
it is advisable to carry out a brief dry dispensing run
after each use. Keep the tips clean at all times using a
cloth dampened in lukewarm water. Only leave the steam wand
immersed in the milk for the time needed to heat it.
Do not open the steam valve with the steam wand im-
mersed in milk and the machine switched off, as the
latter would suck milk into the pipes.
USER manual
Steam ON/OFF
8
9
10

Dispensing hot water

6.8
6.8.1

Dispensing

Danger of scalding. Do not direct hot water towards
hands or other parts of the body. Do not touch the hot
water nozzle with bare hands; use the appropriate
PPE.
• Place the jug under the hot water nozzle;
• press the water button (6)
to be dispensed;
4
4
• The machine dispenses a programmed quantity of hot wa-
ter; to stop it from dispensing ahead of time, press the hot
water dispensing button (6) again
6.8.2

Programming the hot water

The machine is programmed by default. Should the hot water
doses need to be modified, proceed as follows:
• Place the pot under the hot water spout;
• press and hold the
STOP
PROG.
least 5 seconds: the button will start to flash;
• press the hot water dispensing button
pensing;
• when the desired amount of water has been reached, press
the button again to confirm the dose;
• When you have finished programming, press the
ton to exit.
If the water temperature is too low, and if the mixed
water regulation system is present, it can be adjusted
by contacting the Technician.
WBAR
and wait for the hot water
6
4
.
button (of any keyboard) for at
to start dis-
STOP
PROG.
39
but-
160
di