Dispensing Coffee; Preparing The Filter Holder; Dispensing; Programming The Coffee - Wega WBAR EVD Use And Maintenance Manual

WBAR

Dispensing coffee

6.6
6.6.1

Preparing the filter holder

Before filling the filter holder, make sure it is empty
and any previous coffee residue has been removed.
• Fill the filter with a dose of ground coffee (approx. 6-7 g);
follow the procedures specified by the manufacturer of the
grinder-dispenser.
• Compress the coffee with the special press.
• Clean the rim of the ground coffee filter before attaching
the filter holder to the dispensing group.
• Hook the filter holder to the group without closing it too
tightly in order to prevent the gasket from wearing quickly.
6.6.2

Dispensing

Do not remove the filter holder from the dispensing
group when coffee is being dispensed.
• Place the cup under the dispensing spout;
• Press the desired dose button, e.g
coffee to be dispensed (LED will switch on).;
• To stop the coffee dispensing ahead of time, press the
or the button.
STOP
PROG.
Should an anomaly occur or the push button panel
freeze, use the manual switch
38 160
di
6.6.3
The machine is programmed by default. Should the coffee
doses need to be modified, proceed as follows:
• Always programme the pushbutton panel of the leftmost
group first. This way, all the pushbutton panels will be au-
tomatically programmed. If necessary, subsequently pro-
gramme the others;
• place a cup/demitasse under the group's dispensing spout;
• press the
dose button LEDs are lit;
• all the buttons are lit; this means that they dispense the
factory-set quantity;
• Press the dose button that you would like to programme:
e.g.
grammed);
and wait for the
• to confirm the dose, press the
• in this case, the
has already been programmed;
• if desired, repeat this operation for the other dose buttons;
• when all the buttons have been programmed, press the
one by one as illustrated above.
.

Programming the coffee

Each dose must be programmed with freshly ground
coffee and not with previously-used coffee grounds.
button for at least 5 seconds, until all the
STOP
PROG.
(the button will flash whilst it is being pro-
button;
STOP
PROG.
button will go off to indicate that it
button.
STOP
PROG.
All the groups will now be programmed this way.
Should you wish to programme them differently, pro-
ceed to singularly programme the left-hand groups
button again or the
USER manual