MTU Detroit Diesel 183 Series Technical Publication page 487

Task Description
Removal, disassembly, assembly, installation
Removal/disassembly
Remove oil filter - see Operating Instructions.
Remove oil filter head.
Remove oil cooler cover with oil cooler.
Remove oil cooler from oil cooler cover
Remove oil cooler housing from crankcase.
Remove bulkhead wall from oil cooler housing.
Assembly/installation
Replace all gaskets and sealing rings.
Check and clean sealing surfaces.
Install bulkhead wall on oil cooler housing
- observe specified torque.
Install oil cooler housing on crankcase
- observe specified torques.
Install oil cooler on oil cooler cover
- observe specified torques.
- fit graphitised side of gaskets (item 19) in
direction of oil cooler.
Install oil cooler cover with mounted oil cooler on oil cooler housing
- observe specified torques.
Install oil filter head on oil filter cover
- observe specified torque.
Install oil filter - see Operating Instructions.
Fill engine oil system with engine oil, see 18-1601.
Check and correct coolant level - see Operating Instructions.
Oil priming and engine starting - see 18-1601.
Switch off the engine, check the oil cooler for leaks.
After approx. 5 minutes check and correct the engine oil and coolant levels.
20080/1 E 98-12
Group 18
Subgroup 7109a
Page 3