Group
03
Subgroup
8001
Page
2
20080/1 E 98-12
Removal/installation
Remove flywheel screws (2).
Installation instructions
Measure shaft length (max. 75 mm) of flywheel screws.
Apply a thin coat of oil when assembling.
Tightening torques:
1 Stage 200 to 220 Nm.
2 Stage 90° to 100° angle of rotation
Insert guide mandrels into two opposing threaded
bores.
Guide mandrel 403 589 02 63 00.
Remove flywheel via guide mandrels.
Installation instructions
Centering pin in crankshaft gear and centering bore in
flywheel must be aligned.
Install in reverse order.
Task Description