MTU Detroit Diesel 183 Series Technical Publication page 128

Group 01
Subgroup 9324
Page 2
20080/1 E 98-12
Removal
Mark the cylinder liners to the crankcase (arrow).
Note:
Before operating the liner removal tool, check the
spacer sleeve (4) and, if necessary, shorten to a level
of 175 mm.
Insert stud screws (5) in opposite threaded bores for
cylinder head screws.
Extractor and installation tool 403 589 00 33 00
Insert liner extractor in cylinder liner.
Separate the gripping jaws of the extractor by turning
until they reach the inner diameter of the cylinder liner
on the spindle.
Note:
Apply the gripping jaws of the extractor only lightly.
Mount counter support on studs and tighten.
Pull out cylinder liners by turning the hexagon nut
(arrow). Hold spindle in place when doing this.
Turn at the spindle until the gripping jaws of the
extractor come together. Unscrew counter screws and
lift off with extractor.
Extractor and installation tool 403 589 00 33 00
Remove the cylinder liner from the crankcase.
Remove the O-rings from the crankcase and from the
cylinder line.
Clean cylinder liners, bore, liner collar, liner support and
grooves for O-rings.
Note:
Check repair stage or dimensional accuracy before
installing cylinder liner.
See Tolerance and Wear Limits List (01-9324).
Task Description