MTU Detroit Diesel 183 Series Technical Publication page 135

Task Description
20080/1 E 98-12
Insert stud screws for the extractor and installation tool
in the threaded bores for the cylinder head screws
opposite.
Place the pressure plate (arrow) on the cylinder liner.
Place the extractor (spindle with counter support) on
stud screws and tighten.
Removal and installation tool 403 589 00 33 00
Press in the cylinder liner by turning the spindle.
Lift the installation tool off the cylinder crankcase.
Measure cylinder liner protrusion (01-9314).
Using a bore gauge, measure inside diameter of the
liner in the area of the lower fit at three points (each
time offset by 60°).
See Tolerance and Wear Limits List for limit values 01-
9324.
Notes
>If the out-of-round measured is greater than 0.04 mm,
a security check of the lower sealing ring must be
carried out.
- If the pistons being reinstalled during repair have
already been used, always replace the second piston
ring.
Dial gauge 001 589 53 21 00
Group 01
Subgroup 9324
Page 9