MTU Detroit Diesel 183 Series Technical Publication page 269

Task Description
20080/1 E 98-12
Insert bearing retainer (9) into bearing bore and insert
stop element (10) into groove behind bearing retainer
(9).
Turn cross handle clockwise and remove camshaft
bearing.
Collar bearing (21) is pressed out at rear. For this
purpose, connect cross handle with bearing flange by
means of shell half.
Remove cross handle and spindle pipe. Remove
bearing retainers and collar bearing (21) and remove
bearing flange.
Clean bearings in crankcase.
Installation
Insert centring pipe (7) into bearing bore and secure
bearing flange (5) with two hex bolts M10x25 to
crankcase.
Group 05
Subgroup 7102
Page 5