MTU Detroit Diesel 183 Series Technical Publication page 47

General
00-0006 Data Sheets
To ensure that unusable components are not re-installed, or that usable components are not discarded, all
inspection work should only be carried out only by qualified personnel using the necessary measuring instruments.
All measuring and testing equipment is naturally subject to wear.
In order to register the resulting tolerance deviations in good time, the measuring and test equipment must be
inspected annually at a location equipped with the appropriate technical facilities.
Alternatively, an inspection can be carried out through our Product Support service and DaimlerChrysler/MTU or by
an external Product Support service.
On no account are the measurements to exceed or fall short of the values given in the Tolerance and Wear Limits
List.
Data sheets are to be used to record the inspection results.
20080/1 E 98-12
Group 00
Subgroup 0006
Page 1