MTU Detroit Diesel 183 Series Technical Publication page 308

Group 07
Subgroup 6750
Page 4
Individual parts to be cleaned must be completely covered with cleaning fluid.
Directly after cleaning, wash parts in diesel fuel, blow out with compressed air and immerse the cleaned parts
immediately in clean test oil and/or purified diesel oil.
20080/1 E 98-12
Cleaning complete nozzle holder combinations:
Position nozzle holder combinations vertically into the
bracket
ED 8 and clean in the ultrasonic bath.
The duration of the cleaning process depends on the
level of contamination but must be at least 10 minutes.
Cleaning nozzle elements:
When cleaning the nozzle elements, remove the nozzle
needle completely from the body and clean two parts
separately. To do so, position nozzle body vertically in
holder ED 8 with orifices pointing downwards.
Ensure that needle and body are not interchanged
with parts of other nozzles.
The duration of the cleaning process depends on the
level of contamination but must be at least 10 minutes.
Cleaning individual parts of nozzle holder:
Position individual parts of nozzle holder in basket K 3
S.
Ensure that parts are not interchanged with other
nozzle holders.
The duration of the cleaning process depends on the
level of contamination but must be at least 10 minutes.
Task Description