MTU Detroit Diesel 183 Series Technical Publication page 130

Group 01
Subgroup 9324
Page 4
20080/1 E 98-12
If liners are to be re-used, the hone pattern over the
total surface must be more or less quite recognizable.
Individual light scorings when extracting are not critical.
No signs of wear should be felt at the return stroke
position of the first piston ring.
Measure cylinder liner bore.
Adjust the internal bore guage (1) and dial gauge with
either micrometer or gauge ring (2) to the basic liner
bore dimension as given in the Tolerances and Wear
Limits List
01-9324.
Measure liner bore with gauge.
Refer to the Tolerance and Wear Limits List for
measuring levels and limit values (01-9324).
If limit values are exceeded, replace liner.
Task Description