MTU Detroit Diesel 183 Series Technical Publication page 143

Task Description
20080/1 E 98-12
Heat the inner race for roller bearing - PTO side - to
approx. 80°C and mount on the shaft (5).
Risk of injury!
Mount the roller bearing (8) on the inner bearing race.
Heat the track ring (9) for the shaft seal to approx. 80°C
and mount on the shaft (5).
Risk of injury!
Oil both bearings.
Insert spacer sleeve in the housing bush.
Note
Take care not to damage stop catch.
Insert shaft with bearing in the housing bush.
Note
When inserting the shaft, mount the drive gear over the
taper spline and insert in the new securing nuts over the
shaft thread.
Group
Subgroup
Page
Notice!
Notice!
01
9444
7