MTU Detroit Diesel 183 Series Technical Publication page 358

Group 09
Subgroup 6030a Task Description
Page 4
Installation
Note:
Carry out installation operations in accordance with arrangement drawings 506 002 27 14 and 506 002 28 14.
Exhaust line and carrier housing lower section are installed.
Fit plug-in pipes (8) in exhaust line (7).
Installation instructions:
Plug-in pipe with bores in long duct (direction of exhaust outlet).
Coat new O-ring (5) with petroleum jelly and fit in carrier housing lower section.
Place locating pins (4) for carrier housing upper section at hand, but do not insert.
Fit new R-rings (piston rings) on turbocharger turbine outlet.
Coat flange of bearing housing (3) and / or opposite carrier housing sealing surface on contact face of carrier
housing lower section / bearing housing (axial) with sealing paste, part No. 50545.
Insert exhaust turbocharger in carrier housing lower section with a distance to the bolt-on surface, threading plug-in
pipes (8) in turbocharger.
Installation instructions
Make absolutely sure that no sealing paste is scraped off.
Fit sealing ring (5), then position turbocharger axially on the flange surface by means of its securing screws with tab
washers.
Coat new O-rings with petroleum jelly and fit in carrier housing lower section.
20080/1 E 98-12