MTU Detroit Diesel 183 Series Technical Publication page 122

Group 01
Subgroup 9304
Page 6
20080/1 E 98-12
Turn over driving crank (4) evenly in a clockwise
direction while holding the face feed ring (7).
Note
The advance nut (5) must remain firmly in position.
Turn over driving crank (4) until the turning chisel
reaches the cylinder bore outer diameter.
The turning chisel has been ground in a such a way to
ensure that the desired diameter is not exceeded. The
front face of the chisel runs around the cylinder
bore diameter. If the driving crank is difficult to move,
release the face feed ring and turn the crank a few
times.
Note
The turning chisel should only be grounded according
to the drawing which is enclosed with the grinding
machine.
Every time the equipment is turned over, measure the
balcony depth from the plane surface of the turning
device:
A Turning device with measuring point
Secure dial gauge with extension (arrow)
(approx. 26 mm) to gauge holder.
Dial gauge
Dial gauge holder
Mount the dial gauge holder with dial gauge on the
plane surface of the turning device and mount the dial
gauge feeler to the liner collar (arrow).
Check pretension (approx. 3 - 4 mm) of the dial gauge.
Set scale of dial gauge to "0".
Task Description
001 589 53 21 00
343 589 00 40 00