MTU Detroit Diesel 183 Series Technical Publication page 142

Group 01
Subgroup 9444
Page 6
20080/1 E 98-12
Heat gear case with a hot air blower and drive the
housing bush (3) into the gear case.
Heat the inner race for rear bearing (4) on a heating
plate to approx. 80°C and - on the drive side - mount on
the shaft (5).
Risk of injury!
Heat the first half of the divided angular-contact ball
bearing inner race to approx. 80°C and - on the PTO
side - mount on the shaft (5).
Risk of injury!
Mount the angular-contact ball bearing (7) on the inner
bearing race.
Heat the second half of the divided angular-contact ball
bearing inner race to approx. 80° and mount on the
shaft (5).
Risk of injury!
Ensure bearing (7) is firmly seated.
Task Description
Notice!
Notice!
Notice!