Table of Contents
Advertisement
6.1
Testing the charging system
Fig. 30: Function simulator
6.2
System start-up
After the charging system has been correctly installed, the system can be started.
1.
Switch on the power supply.
2.
Switch on the line and residual current circuit breaker.
The system starts up.
The duration of the system start-up may vary depending on the type of charging system, configuration
and product characteristics. The successful completion of the system start-up is indicated by the
status LEDs and the display according to the configuration and product scope of the charging system.
The average start-up time is approx. 60 seconds.
A successful system start-up is indicated by the LED of the respective charging point temporarily
lighting up green. In the case of a charging system with display, the message "Ready for operation" also
appears for the respective charging point.
2022-11
The functionality of the installed charging system
can be tested either with a vehicle or with a
function simulator.
With the function simulator it is possible to
simulate the functions of an electric vehicle and
check the functionality of a charging system or
charging point.
The figure shows an example of a function
simulator for testing an AC charging system or AC
charging point.
Another suitable test device must be used for all
metrological tests.
A01Axxxxxx.xx | 04
51
Advertisement
Table of Contents
