Table of Contents
Advertisement
5.8 Mounting the terminal box (single-sided pillar)
Installation material and tools
•
5 nuts (M10, V4A) (accessory kit)
•
5 large diameter washers (DIN 9021 10.5 mm, V2A) (accessory kit)
•
Open-end or ring wrench SW 17
•
Torque wrench
Fig. 13: Boreholes
NOTE
The further steps for installation and connection of the charging system are described from the
chapter 5.10.2 External supply line, page 39.
2022-11
4
5
3
2
1
A01Axxxxxx.xx | 04
Carrying out installation
1.
Push the terminal box onto the 5 threaded
bolts of the pillar.
2.
Place the large diameter washers on the
threaded bolts.
3.
Screw nuts onto the threaded bolts and
hand-tighten.
4.
Check the terminal box for correct seating
and tighten the nuts in the sequence 3-4-
2-1-5. Observe the corresponding
tightening torques!
5.
Break out and deburr the lower pre-punched
bushings in the terminal box.
35
Advertisement
Table of Contents
