Table of Contents
Advertisement
5.7.2
Installing the pillar
Installation material and tools
•
- Matching screw connection to selected ground anchorage
•
4 large diameter washers (DIN 9021 10.5 mm, V2A) (not in scope of delivery)
•
Open-end or ring wrench SW 17
•
Torque wrench
Fig. 12: Screw connection
34
Carrying out installation
1.
Place the pillar over the inserted ground
anchors. While doing so, carefully pull the
supply lines further out of the upper
opening to avoid looping.
2.
Align the pillar so that the fixing holes are
aligned with the mounting points of the
ground anchorage. Check that no supply
lines are crushed!
3.
Place washers over the mounting holes of
the pillar, insert the screw fasteners
through and hand-tighten them.
4.
Check the connection and the pillar for
correct fit and tighten the screw
connections crosswise. Observe the
corresponding tightening torques!
A01Axxxxxx.xx | 04
2022-11
Advertisement
Table of Contents
