Table of Contents
Advertisement
5.10.7 Mounting the bottom shell
6
Fig. 20: Bottom shell fixing points
2022-11
1.
Guide the cables to be connected through the
openings provided for this purpose in the bottom shell.
2.
Hook the lower shell onto the retaining bar of the
connection box at an angle of 45° and slowly swing it
downwards to the wall support. Make sure that the
bottom shell is correctly and completely seated.
3.
Preliminarily secure the bottom shell against falling
down using the screws supplied (raised head 4 x
12 mm) in mounting holes (2) and (3).
4.
Unclip the lower lighting strip (6) on the left-hand side
so that the fixing hole (1) is accessible.
1
5.
Screw in all 5 fastening screws (1 - 5) completely.
Observe the correct torque (M = 1.5 Nm).
6.
Re-engage the lower lighting strip.
2
7.
For the optionally supplied profile half-cylinder lock,
3
break out and deburr the pre-punched opening on the
underside of the bottom shell before fitting.
4
5
A01Axxxxxx.xx | 04
43
Advertisement
Table of Contents
