Fuji Electric MONITOUCH X1 Series Hardware Specifications page 8

[Notes on the Capacitive Touch Switch]
• Touch switches may be unresponsive if touched with dry fingers. In such a case, use a capacitive stylus pen.
• Touch switches are calibrated each time the power is turned on. Do not touch the screen for 10 seconds immediately after turning the
X1 series on. Otherwise, malfunctions may occur.
• When a metal object is near a touch switch for 5 minutes or longer, the touch switch is calibrated to recognize that state as the default
state. Note that after the metal object is removed, the touch switch will become inoperable.
• Water droplets or conductive material can cause the sensor to make a false detection and lead to malfunctions.
• When using multi-touch operations, points must be at least 3 cm apart. Points may not be recognized if in close proximity of each
other.
• In an environment with excess noise, the responsiveness of touch switches may be lowered and the point that responds may deviate
by up to 1 cm. Implement measures such as adding a filter to the input power supply.
• Periodically clean the touch panel surface for optimum touch operations.
When cleaning, take note of the following points.
<When cleaning>
- The panel surface is made of glass. Be sure to clean the surface gently with a cloth or sponge. Otherwise, you may scratch or
damage the glass.
- Take care not to let cleaning detergent to seep into the touch panel unit.
Do not directly apply or spray cleaning detergent on the panel surface.
[Notes on the Operating System (OS) and Scope of Operation Guarantee]
• The operating system (OS) used on this product is the Windows 10 IoT Enterprise LTSC by Microsoft. Therefore, Windows Update is
not applicable to this OS. Also, the apps Cortana, Microsoft Edge, Microsoft Store, and UWP are not supported.
• Custom user apps for use on Windows can be used on this product. Hakko Electronics does not guarantee the operation of apps
installed by the customer. Make sure to thoroughly check the operation before actual use.
• Hakko Electronics shall not be held responsible for dealing with trouble or liable for damages stemming from Microsoft products
while using this product. When trouble occurs with a Microsoft product or there is a need to check the specifications, refer to the
manual of the Microsoft product or contact Microsoft. Refer to the following website to contact Microsoft.
https://support.microsoft.com/en-us/contactus/
[Notes on Turning Power Off]
The System Configurator built into the X1 series unit provides a write filter function. When the write filter function is enabled, the power
of the X1 series unit can be turned off suddenly without damaging system files. If the write filter function is disabled, the shutdown
procedure is necessary. Perform the shutdown procedure on System Configurator and after waiting for at least 15 seconds from when the
screen has gone out, turn the X1 series unit power off.
[Notes on the Built-in Solid-state Drive (SSD)]
• The X1 series unit has a built-in SSD (C drive). Do not change partitions or split the drive.
• 3D NAND is used in the built-in SSD of the X1 series unit. Keep in mind the service life of the SSD.
[Notes on the Battery]
The X1 series unit has a built-in battery which is used for backing up time data and BIOS settings (retention during power outage). The
battery must be replaced within three years after the unit is purchased. Note that the X1 series unit can start up in the same way as usual
even if time data and BIOS settings are lost. Time data is reset to the default value in such a case. Set again as necessary.
[Notes on Wireless LAN]
For details regarding supported wireless LAN standards, radio law certifications, and countries where wireless LAN can be used, refer to
the "X1 Series Notes on Wireless LAN" manual provided with the X1 series unit at delivery.
[Notes on the Startup Time]
Since a Windows OS is used, the startup time differs depending on the devices that are connected and software that is additionally
installed.
Carefully consider devices and software before use.