System Menu And Status Bar; System Menu - Fuji Electric MONITOUCH X1 Series Hardware Specifications

5.2

System Menu and Status Bar

5.2.1 System Menu

The system menu is used to switch between the RUN and Local modes of the X1 app and change the display brightness.
Display Method
RUN mode
Press two of the four corners of the X1 series unit screen one by one to display the system menu.
Recognition area
1. Press one corner of the screen for at least 2 seconds and release your finger when there is a beep.
Press the upper left corner
for at least 2 seconds.
2. Then within one second, press a different corner and hold for at least 2 seconds to display the system menu.
Press a different corner for at least 2 seconds.
* If any of the items given below are placed in a corner on the screen, the system menu will not be displayed. Be sure to press a corner
where none of the items are placed. If these items are placed in all four corners of the screen, switch the screen to one that has open
corners and perform the above procedure to display the system menu.
Switches, data display parts with switches, display areas, scrolling messages, slider switches, scroll bars, and table data display parts
Local mode
Press the [Display system menu] switch.
2 cm
2 cm
5.2
2 cm
Recognition area
2 cm
System menu
System Menu and Status Bar
5-3
1
2
3
4
5
6
7
8
9
10