Hard Copy Setting; Serial Setting - Fuji Electric MONITOUCH X1 Series Hardware Specifications

5 Operation Method

Hard Copy Setting

The [Hard Copy Setting] tab window on the System Setting screen is used to change the hard copy setting.
Item
Reversed Image

Serial Setting

The [Serial Setting] tab window on the System Setting screen is used to set the signal level for serial communication (RS-422/RS-485).
This setting is necessary when all of the following three conditions apply.
• The [Target Port No.] is set to [SERIAL] for PLCx in the [Hardware Setting] window of a screen program.
• The [Signal Level] setting is set to [RS-422/485] at either of the following locations:
[Hardware Setting]  [PLCx Properties] in the screen program
[Comm. Setting]  [Communication Parameter] in Local mode
• A connected device supports both RS-485 (2-wire connection) and RS-422 (4-wire connection) and RS-422 is used for connection.
Item
Specify signal level
This setting is invalid when [Signal Level] is set to [RS-232C].
5-44
[Hard Copy Setting] tab window
Unselected Black and white are not inverted.
Selected Black and white are inverted.
[Serial Setting] tab window
Unselected Automatic recognition
• On models that support RS-485 (2-wire connection) only, RS-485 is used for connection.
• On models that support RS-422 (4-wire connection) only, RS-422 is used for connection.
• On models that support both RS-485 (2-wire connection) and RS-422 (4-wire
Selected Select either RS-485 (2-wire connection) or RS-422 (4-wire connection).
connection), RS-485 is used for connection.
Press the [Apply] switch
to confirm the settings.
Description
Press the [Apply] switch
to confirm the settings.
Description