Fuji Electric MONITOUCH X1 Series Hardware Specifications page 155

5 Operation Method
Calibration
Perform calibration when touch switches are not responding or do not respond well. While executing calibration, "Processing..." is
displayed on the screen.
After executing, check operations from the [Operation check] switch.
Do not touch the screen during calibration.
Touch Display Selection
If a display that supports touch operations is connected via the HDMI port but the touch operations of the display are not recognized,
configure settings on the following screen.
• A keyboard is required for these settings. Be sure to connect a keyboard.
• If the external display does not support touch operations, these settings are not necessary.
1. Tap [Tablet PC Settings] → [Setup].
2. The following window is displayed on the X1 series unit. Press the [Enter] key on the keyboard to proceed.
3. The same screen is displayed on the external display. Tap the screen according to the displayed instructions. The next window is
displayed. Press the [Enter] key on the keyboard to complete settings.
Displayed on X1: Press [Enter] or [Esc]
Displayed on the external display: Tap the screen
4. Tap [Tablet PC Settings] → [OK] to return to the System Configurator screen.
5-96