Specifications Of Components; Lan / Lan2 - Fuji Electric MONITOUCH X1 Series Hardware Specifications

2.4

Specifications of Components

2.4.1 LAN / LAN2

These connectors are used for Ethernet communication with an upper-layer PC and controllers.
Specifications
Item
Number of Ports 2
Connector RJ-45
Applicable Standards IEEE802.3 compliant
IEEE802.3u compliant
IEEE802.3ab compliant
Baud Rate 10Mbps / 100Mbps / 1.0Gbps
Protocol TCP/IP, UDP/IP
Function
Auto-MDIX
Recommended Cable 100  STP (shielded twist-pair) cable, category 5e or above, max. 100-m long
Applications Screen program transfer, PLC connection, upper-layer PC connection, printer connection, etc.
*1 Both straight and cross cables are usable, irrespective of the presence or absence of a hub.
Pin numbers and signal names
LAN
1 2 3 4 5 6 7 8
LED
LAN
A B
Wiring
• The SERIAL and LAN/LAN2 connectors are 8-pin modular jacks. Check the connector names on the unit and insert
cables into the correct connectors.
• Do not connect any peripheral device that will carry excess voltage to the LAN/LAN2 connector.
• Use a commercially available cable. Using a custom-made cable may cause an error in network connection.
Bottom view
: 10BASE-T
: 100BASE-TX
: 1000BASE-T
*1
, Auto-Negotiation
Pin No. 10BASE-T / 100BASE-TX
1 TX+
2 TX
3 RX+
4 NC
5 NC
6 RX-
7 NC
8 NC
A: Activity LED B: Speed LED
On Off
On Lit green
On Lit orange
2.4
Specification
Transmit signal + BI_DA +
Transmit signal  BI_DA 
Receive signal + BI_DB +
Not used BI_DC +
Not used BI_DC 
Receive signal  BI_DB 
Not used BI_DD +
Not used BI_DD 
Status
10BASE link established / Data is being transmitted
100BASE link established / Data is being transmitted
1000BASE link established / Data is being transmitted
Specifications of Components
1000BASE-T
Transmit/receive data A+
Transmit/receive data A
Transmit/receive data B+
Transmit/receive data C+
Transmit/receive data C
Transmit/receive data B
Transmit/receive data D+
Transmit/receive data D
2-9
1
2
3
4
5
6
7
8
9
10