Fuji Electric MONITOUCH X1 Series Hardware Specifications page 112

Message Dialog Displayed during Data Transfer
If an error occurs during data transfer, the message dialog is displayed on the X1 series unit.
Messages and their contents are shown below.
Messages
Work normally finished. The specified operation has been concluded normally.
Storage is not connected Storage is not connected
Storage Capacity over Cannot write data to a storage device because the data size in the X1 series unit is larger than the capacity of the storage
device.
Selected data does not exist. The data does not exist in the reading target.
Selected data cannot be read. Data in the storage device cannot be read.
Reading Error occurred. An error occurred during writing to the flash ROM of the X1 series unit, comparing data, or reading storage information.
Data discrepant Data comparison found a discrepancy between the storage device and the X1 series unit.
Undefined Error occurred. The USB storage is write protected.
Description
5.4 Local Mode
1
2
3
4
5
6
7
8
9
10
5-53