Setting Procedure (For An Existing Unit) - Fuji Electric MONITOUCH X1 Series Hardware Specifications

4.3

Setting Procedure (For an existing unit)

For an existing X1 series unit, the sequence from power on up to transferring a screen program is as shown below.
The IP address can be changed by starting System Configurator from Local mode.
For detailed setting procedures, refer to the X1 Series Setup Manual.
Turn power on.
HMI app starts.
Local mode
"5.4.1 Switching to Local Mode" page 5-17
Check the IP address.
Using the IP Changing the
address as is IP address
Start System Configurator.
<Method 1>
Reboot
HMI app starts.
Local mode
Start System Configurator.
Reboot
HMI app starts.
Screen program transfer
• [System Information] (LAN only)
• [LAN Setting] / [LAN2 Setting]
• Status bar "5.2.2 Status Bar" page 5-11
"5.5 System Configurator" page 5-66
Set [Write filter setting] to [Invalid].
"Write Filter Setting" page 5-75
"5.4.1 Switching to Local Mode" page 5-17
"5.5 System Configurator" page 5-66
IP address setting
"IP Address Setting" page 5-69
Set [Write filter setting] to [Valid].
"Write Filter Setting" page 5-75
4.3 Setting Procedure (For an existing unit)
*1
"MONITOUCH Information" page 5-21
"5.4.6 LAN Setting / LAN2 Setting" page 5-25
Write filter setting: Valid
<Method 2>
Set [Startup settings (operation
mode)] to [System Configurator].
"Startup Settings (Operation Mode)"
page 5-81
Reboot
System Configurator
Set [Write filter setting] to [Invalid].
"Write Filter Setting" page 5-75
Reboot
System Configurator
IP address setting
"IP Address Setting" page 5-69
Set [Startup settings
(operation mode)] to [HMI].
"Startup Settings (Operation Mode)"
page 5-81
Write filter setting: Invalid
* Turn the power off and reboot after
pressing the [Shutdown] button in
System Configurator.
Reboot
Write filter setting: Valid
1
2
3
4
5
6
7
8
9
10
4-3