Setup Error; Screen Program Error - Fuji Electric MONITOUCH X1 Series Hardware Specifications

6.1 Errors
There are three kinds of error messages displayed on the X1 series:

• Setup error

(page 6-1)

• Screen program error

(page
• Communication error (page
6.1.1 Setup Error
When no screen program is present or no system program has been transferred, the following message is displayed on the X1 series unit.
Solve the error according to the error message.
When the [Retry] switch is pressed, the operation mode switches to RUN mode.
6.1.2 Screen Program Error
When an error is found in the screen program, the following message is displayed on the X1 series unit.
For details on error numbers, refer to
When the [Retry] switch is pressed, the operation mode switches to RUN mode.
6-1)
6-5)
page 6-7.
Setup Error
Screen Data not setting.
* The error is also displayed in Local mode.
Screen Data Error
Error: 163(SRAM:7)The SRAM/clock setting does not match the SRAM area format.
* The error is also displayed on the Local mode screen.
6.1 Errors
1
2
3
4
5
6
7
8
9
10
6-1