Serial - Fuji Electric MONITOUCH X1 Series Hardware Specifications

2 Specifications

2.4.2 SERIAL

This connector is used for serial connection with controllers.
Specifications
Item
Number of Ports 1
Connector RJ-45
Communication Standard
RS-232C / RS-485 (2-wire connection) / RS-422 (4-wire connection)
Synchronization Asynchronous type
Data Length 7 / 8 bits
Parity None / Even / Odd
Stop Bit 1 / 2 bits
Baud Rate 4800 / 9600 / 19200 / 38400 / 57600 / 76800 / 115200bps
Applications PLC, temperature controller, etc.
*1 Select the signal level on the [Hardware Setting] window of the screen configuration software or local mode on the X1 series unit.
When selecting the RS-422 (4-wire connection) signal level for connection with a controller that supports both RS-485 (2-wire connection) and RS-422
(4-wire connection), select in the local mode on the X1 series unit. Refer to
Pin numbers and signal names
LAN
1 2 3 4 5 6 7 8
* The frame ground (FG) and signal ground (SG) are connected inside the unit.
Recommended cable
AWG 26 stranded wire, braided shield
* Check the operation in advance in the usage environment.
2-10
Pin No. RS-232C
1 RD Receive
2 NC
3 NC
4 NC
5 SG Signal ground
6 SG Signal ground
7 SD Transmit
8 NC
Bottom view
Specification
*1
"Serial Setting" page 5-44.
RS-485 (2-wire connection)
+ Transmit/receive +
- - Transmit/receive 
- NC
- NC
SG Signal ground
SG Signal ground
NC
- NC
RS-422 (4-wire connection)
+SD Transmit +
-SD Transmit 
- NC
- NC
SG Signal ground
SG Signal ground
- +RD Receive +
- -RD Receive 
-
-