Switching To Local Mode - Fuji Electric MONITOUCH X1 Series Hardware Specifications

5.4.1 Switching to Local Mode

Switching from RUN mode to Local mode can be done by either of the following methods.
Method 1: system menu
1. Press one corner of the screen
2. Then within one second, press a different corner
3. Press the [Local] switch on the displayed system menu.
Splash screen
Progress bar
*1 If any of the items given below are placed in a corner on the screen, the system menu will not be displayed. Be sure to press a corner
where none of the items are placed. If these items are placed in all four corners of the screen, switch the screen to one that has open
corners and perform the above procedure to display the system menu.
Switches, data display parts with switches, display areas, scrolling messages, slider switches, scroll bars, and table data display parts
*2 The splash screen can be changed as desired. For details, refer to X1 Series Reference Manual 2.
*1
for at least 2 seconds and release your finger when there is a beep.
*1
and hold for at least 2 seconds to display the system menu.
*2
Message
Recognition area
2 cm 2 cm
2 cm 2 cm
System menu
Local mode screen
5.4 Local Mode
1
2
3
4
5
6
7
8
9
10
5-17