Fuji Electric MONITOUCH X1 Series Hardware Specifications page 129

5 Operation Method
LAN / LAN2 / WLAN
Manual
Item
IP address allocation
Automatically allocated IP address
IP Address
Subnet Mask
*1
Gateway
DNS server 1
DNS server 2
Speed and duplex
*1 The X1 series unit can have only one gateway. The gateway cannot be set for multiple ports.
After changing the IP address, be sure to set [Settings]  [Write filter setting] to [Valid].
If you exit System Configurator with the setting set to [Invalid], the [LAN], [LAN2] and [WLAN] settings on the X1 app will
not be updated.
Methods for inputting numbers and text
• Use the System Configurator  [System keyboard]. Refer to
• Connect a USB keyboard.
5-70
Auto
Select the method for setting the IP address.
Manual: Input the IP address on this screen.
Auto: Press the [OK] switch and an IP address is automatically allocated by the DHCP server.
Auto
Indicates the IP address allocated by the DHCP server.
-
-
-
Set the address of the preferred DNS server.
Set the address of the alternate DNS server.
Set the speed and duplex mode.
Auto-negotiation (default): Automatic setting through correspondence with the connected device
10 Mbps half duplex: 10 Mbps, bidirectional transmission, one direction at a time
10 Mbps full duplex: 10 Mbps, bidirectional transmission, simultaneous
100 Mbps half duplex: 100 Mbps, bidirectional transmission, one direction at a time
100 Mbps full duplex: 100 Mbps, bidirectional transmission, simultaneous
1.0 Gbps full duplex: 1.0 Gbps, bidirectional transmission, simultaneous
Back
Description
Set the IP address.
Default
LAN: 192.168.0.100
LAN2: 192.168.1.100
WLAN: 192.168.10.100
Set the subnet mask.
Set the gateway.
page 5-93.
Manual
-