wan enable
The wan enable AP configuration mode command accommodates certain timing constrains in the communication
to a remotely connected wireless AP separated by a WAN link or the Internet. To disable WAN support, use the no
form of this command.
Syntax
wan enable
no wan enable
Parameters
This command has no keywords or arguments.
Default Configuration
Disabled
Command Mode
AP Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example accommodates certain timing constrains in the communication to a remotely connected
wireless AP separated by a WAN link or the Internet.
Console (Config)# wlan ap CR1 config
Console (Config-ap)# wan enable
Wireless AP General Commands
Page 486
wan enable