Deny (Management) - D-Link xStack DWS-3200 Series Cli Manual

deny (Management)

The deny Management Access-List Configuration mode command defines a deny rule.
Syntax
deny [ethernet interface-number | vlan vlan-id | port-channel port-channel-number |] [service service]
deny ip-source ip-address [mask mask | prefix-length] [ethernet interface-number | vlan vlan-id | port-channel
port-channel-number |] [service service]
Parameters
•
interface-number — A valid Ethernet port number.
•
vlan-id — A valid VLAN number.
•
port-channel-number — A valid port-channel number.
•
ip-address — A valid source IP address.
•
mask — A valid network mask of the source IP address.
•
mask prefix-length — Specifies the number of bits that comprise the source IP address prefix. The prefix
length must be preceded by a forward slash (/). (Range: 0-32)
•
service — Service type. Possible values: telnet, ssh, http, https and snmp.
Default Configuration
This command has no default configuration.
Command Mode
Management Access-list Configuration mode
User Guidelines
Rules with Ethernet, VLAN and port-channel parameters are valid only if an IP address is defined on the
appropriate interface.
The system supports up to 128 management access rules.
Example
The following example denies all ports in the access list called 'mlist'.
Console(config)# management access-list mlist
Console(config-macl)# deny
Page 188
Management ACL Commands
deny (Management)